UDMA UDMA33/66/100 change Utility for HN14L/PB16/HN15L series.
File name:udma100c.exe

0) Copy the udma100c.exe file to MS-DOS FDD.
1) Connect target drive to ATA bus.
2) Turn on drive power and PC by MS-DOS FDD.
3) To start this tool, type following filename at command prompt.
     A:\> UDMA100C 33  (for UDMA33 mode setting)
         or
     A:\> UDMA100C 66  (for UDMA66 mode setting)
         or
     A:\> UDMA100C 100 (for Ultra DMA100 mode setting)

New setting will be valid after power off -> on.


//////////////////////////////////////////////////////////////////////
//                                                                  //
//   UDMA Support Level Revising Utility for fujitsu drive.         //
//        PB16/HN14L/HN15L Series - UDMA100 supported drive Only.   //
//        Firmware Development, IDE-fw project. Hirotaka.Iima       //
//        Copyright(C) FUJITSU Ltd. 1999-2001, All rights reserved. //
//                                                                  //
//////////////////////////////////////////////////////////////////////

Version 1.19 Oct.23, 2001

Usage : UDMA100C [33 or 66 or 100]
        Option: [/Master or /Slave], [/PRI or /SEC]
