                                                       2/06/2003

UDMA 33/66/100 change Utility for PB16/HN14L/HN15L/HN16L/V40/Z40 series.
File name:udma100c.exe

0) Copy the udma100c.exe file to MS-DOS FDD.
1) Connect target drive to ATA bus.
2) Turn on drive power and PC by MS-DOS FDD.
3) To start this tool, type following filename at command prompt.
     A:\> UDMA100C 33  (for UDMA33 mode setting)
         or
     A:\> UDMA100C 66  (for UDMA66 mode setting)
         or
     A:\> UDMA100C 100 (for Ultra DMA100 mode setting)

New setting is valid immediately after performing this utility.


//////////////////////////////////////////////////////////////////////
//                                                                  //
//  - UDMA Support Level Revising Utility for FUJITSU drives -      //
//                                                                  //
//     This utility is only for PB16/HN14/HN15/HN16/V40/Z40 drives. //
//     Copyright(C) FUJITSU Ltd. 1999-2003, All rights reserved.    //
//                                                                  //
//////////////////////////////////////////////////////////////////////


Version 2.00 Feb.06, 2003


 Usage : UDMA100C mode [option1] [option2]

          mode    : 33 or 66 or 100
          option1 : /master(default) or /slave
          option2 : /pri   (default) or /sec

 If the drive is connected not to primary master port,
 please specify [option1] and [option2].



