   ************************************************************************
   **                                                                    **
   **                MO Device Driver for Windows NT 4.0                 **
   **                        Version 3.02 SCSI                           **
   **                                                                    **
   **                       For PC/AT compatible                         **
   **                                                                    **
   **                                        Revised: December 24, 1998  **
   ************************************************************************
   All Rights Reserved, Copyright (C) FUJITSU LIMITED 1996-1998


This device driver and MO Formatter support the following configurations;

OS:
- Windows NT Workstation Version 4.0(US, PC/AT compatible)


========
General Notes
========
1. Close all applications you are using with an MO disk before you eject it. Failure to do so could result in a loss of data.

2. Windows NT3.51 / 4.0 can not handle an NTFS formatted disk as a removable disk. If you need to eject an NTFS formatted MO disk, shut down NT, then press the eject button. 
   If you need to use your MO disk as a removable disk under Windows NT 3.51 / 4.0, then you must format the MO disk as a FAT file system. The MO Formatter will automatically format your MO disk as FAT file system.

3. When you access your MO drive with a FAT formatted MO disk, the first access sometimes fails. If you try it for a second time, it works fine.
   This failure occurs because the NT operating system may have some delay in loading the FAT file system driver, which may cause this error. There is no problem with your MO drive.


========
Installation Notes
========
1. To modify drive letters for the MO drives, you can use the MO Driver installation software or the MO Formatter. Refer to manual.txt for details.

2. If the installer does not recognize your MO drive, check the following:
  - Are all the applications closed before installation?
  - Is your MO drive turned on? 
  - Is the cable connected properly?
  - Is your MO drive's SCSI ID used by another SCSI device?
  - Is the SCSI termination set properly?
  - Is your SCSI host adapter card working properly? Refer to your SCSI host adapter card manuals.

3. To install the MO Driver and the MO Formatter, follow the steps as shown below.
  1) Log on Windows NT with administrator privilege.
  2) Insert the "Drivers disk" in your A: drive. (Suppose you are using A: drive.)
  3) Select "Run..." from the "Start" button on the task bar.
  4) Type "A:\SETUP.EXE" and click "OK".
  5) After installation is completed, restart Windows NT to activate the device driver.


========
Formatting Notes
========
1. Never close "MO Formatter" while formatting an MO disk.

2. Never attempt to access your MO disk by another application (such as Explorer) while using MO Formatter.

3. MO Formatter indicates unformatted capacity of the disk which is different from formatted capacity.


