 ************************************************************************
 **                                                                    **
 **                         Installation Manual                        **
 **                                                                    **
 **           FUJITSU  ATAPI-MO(MCA3064AP)  Supplemental Driver        **
 **                           for Windows95                            **
 **                   Ver.1.00(for PC/AT compatibles)                  **
 **                                                                    **
 **                                     (Revised : November 28, 1997)  **
 ************************************************************************
  All Rights Reserved and Copyright(C) Fujitsu Limited 1996, 1997



Table of Contents
=================
1. Preface

2. Installation 

3. Uninstall

4. Trademark and Attention


1. Preface
===========
Thank you for purchasing the Fujitsu ATAPI magneto-optical (MO) disk
drive.
This supplemental device driver  supports  the FUJITSU M25-MCA3064AP
 (128/230/540/640 MB) MO disk drive  and  is used to eliminate Windows95
limitation shown below.

   Windows 95 Original limitation:
   Accessing an unformatted 640MB MO disk after using a 540, 230 or 128MB
   MO disk may cause the system to hang.


2.  Installation
================
The installation source need not be a floppy disk.
Create a folder on your hard disk, and copy all the necessary files into
the folder before installation.
The following installation procedures assume that the installer is in a 
floppy disk drive A.

    1) Insert the installation disk into drive A.
    2) Open the "Start" menu of Task Bar.
    3) Select "Run."
    4) Enter " A:\SETUP.EXE" in the text box and click the OK button.
    5) Follow the instructions displayed on the setup program screen.
    6) After installation is complete, remove the floppy disk and restart
       the computer.

The installer performs installation in the Windows95 environment and then
carries out the following:

    a) Copies FJAPHLP.VXD to the C:\Windows\System\Iosubsys folder.
    b) Creates a DEISL1.ISU file on 
              the C:\Program files\Fujitsu\MCA3064AP\UN3064AP.LOG folder.

 NOTE:
  1) Do not copy any files in \Program files\Fujitsu\MCA3064AP\UN3064AP.LOG
     folder. when you uninstall this driver, all copy files in this folder
     will be deleted.
  2) Do not change DEISL1.ISU file. This file is used by Uninstaller.


3.  Uninstall
==================
(1) Select [Start]-[Setting]-[Control Panel]-[Add/Remove Programs]
    Open the icon of Add/Remove Programs.
(2) Select "Fujitsu ATAPI-MO Supplemental driver" and Remove it.



4.  Trademark and Attention
===========================
This product may not be copied or modified without the prior permission of 
Fujitsu.  
No part of this document may be reproduced in any form or by any means 
without the prior permission of Fujitsu.
MS-DOS and Windows are registered trademarks of US Microsoft Corporation in 
the United States and other countries.
