Push Service

You can enable push service to send notification messages to your mobile devices via Synology's push service server when system status changes or errors occur.

To use an email server hosted by Synology:

1. Tick Send notifications regarding system status via Synology's email server.
2. Enter one or more email addresses in the Recipients field. Email notifications will be sent to your specified addresses.
   Note: Any two addresses should be separated with a semicolon (;).
3. Click Save to continue. You will need to verify your email addresses before being able to receive push notifications. A verification email will be sent to the addresses you have specified. Please follow the steps in the verification email.
4. After verification, click Send a test message and then OK to see if your settings are correct. Check your settings if no test message is received.

To enable mobile device notifications:

1. Tick Enable mobile device notifications box, and then click Save.
2. On your mobile device, install DS cam and log in to Surveillance Station.
3. Back in Surveillance Station, click Send a test message and then OK to send a test notification.
4. Launch DS cam on your mobile device to check whether you have received the test message. Check your settings if no test message is received.

To manage paired mobile devices:

1. Click Manage paired DS cam or Manage paired DS finder to see the list of all paired mobile devices.
   Note: The Manage paired DS finder button will show in this tab only when you have enabled the notification integration function in the Advanced tab.
2. If you want to unpair any of the devices, select a device and click Unpair. You can press and hold Shift or Ctrl to make multiple selections. No notifications will be sent to the unpaired devices unless you pair them up again.
3. Click Close to finish.