1999 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

IEEE Transactions on Antennas and Propagation
Volume 47 Number 3, March 1999

Table of Contents for this issue

Complete paper in PDF format

Scanning and Impedance Properties of TEM Horn Arrays for Transient Radiation

Daniel T. McGrath, Member, IEEE, and Carl E. Baum, Fellow, IEEE

Page 469.

Abstract:

A general concept for ultrawide-band array design using interconnected transverse electromagnetic (TEM) horns is described. At high frequencies (wavelength small compared to unit cell dimensions), the mutual coupling between elements is small and, consequently, the input impedance depends only on the lattice dimensions and not on either scan angle or frequency. At low frequencies (wavelength large compared to unit cell dimensions), the mutual coupling is purposefully made large, by interconnecting the elements to maximize the low-frequency performance. This paper presents the results of analyses using a periodic hybrid finite-element approach to calculate input impedance and scanning performance of generic TEM horn arrays. The limiting case, the planar bicone, is shown to have the frequency-independent property of a self-complementary antenna, making it a useful case for establishing the effects of feed region geometry. Although it radiates bidirectionally, it has the interesting property that its broadside-scan frequency response in the array environment is absolutely flat up to the grating lobe onset limit. A TEM horn array is more unidirectional, but as a consequence suffers both oscillatory variations in the input impedance with frequency and increased limits on minimum achievable rise time.

References

  1. C. E. Baum, "From the electromagnetic pulse to high-power electromagnetics," Proc. IEEE, vol. 80, pp. 789-817, June 1992.
  2. L. Carin and S. Vitebsky, "Short-pulse scattering from and the resonances of buried and surface metal mines," Ultra-Wideband, Short-Pulse Electromagnetics 3, C. E. Baum, L. Carin, and A.P. Stone, Eds.New York: Plenum, 1997, pp. 499-509.
  3. D. V. Giri and C. E. Baum, "Temporal and spectral radiation on boresight of a reflector type of impulse radiating antenna (IRA)," Ultra-Wideband, Short-Pulse Electromagnetics 3, C. E. Baum, L. Carin, and A.P. Stone, Eds.New York: Plenum, 1997, pp. 65-72.
  4. C. E. Baum, "Transient arrays," Ultra-wideband, Short-pulse Electromagnetics 3, C. E. Baum, L. Carin, and A.P. Stone, Eds.New York: Plenum, 1997, pp. 129-138.
  5. M. Buttram, "Potential applications in government and industry," High Power Optically-Activated Solid-State Switches, A. Rosen and F. Zutavern, Eds.Norwood, MA: Artech House, 1994, ch. 1, p. 25.
  6. C. E. Baum, "Some characteristics of planar distributed sources for radiating transient pulses," Sensor Simulation Note #100, U.S. Air Force Weapons Lab., Kirtland AFB, NM, Mar. 1970.
  7. D. T. McGrath and V. Pyati, "Phased-array antenna analysis with the hybrid finite-element method," IEEE Trans. Antennas Propagat., vol. 42, pp. 1625-1630, Dec. 1994.
  8. --, "Periodic structure analysis using a hybrid finite element method," Radio Sci., vol. 31, pp. 1173-1179, Sept./Oct. 1996.
  9. T. K. Sarkar, "On the application of the generalized biconjugate gradient method," J. Electromagn. Waves Applicat., vol. 1, pp. 223-242, 1987.
  10. D. T. McGrath, "Numerical analysis of planar bicone arrays," Sensor Simulation Note No. 403, U.S. Air Force Phillips Lab., Kirtland AFB, NM, Dec. 1996.
  11. G. A. Deschamps, "Properties of complementary multiterminal planar structures," IRE Trans. Antennas Propagat., vol. AP-7, pp. S371-S378, Dec. 1959.
  12. N. Inagaki, Y. Isogai, and Y. Mushiake, "Ichimatsu moyou antenna--Self-complementary antenna with periodic feeding points," IECE Trans., vol. 62, pp. 388-395, 1979.
  13. F. C. Yang and K. S. H. Lee, "Impedance of a two-conical plate transmission line," Sensor Simulation Note #221, U.S. Air Force Phillips Lab., Kirtland AFB, NM, Nov. 1976.