2000 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

IEEE Journal of Lightwave Technology
Volume 18 Number 9, September 2000

Table of Contents for this issue

Complete paper in PDF format

High-Responsivity Fiber-Optic Flexural Disk Accelerometers

Geoffrey A. Cranch and Philip J. Nash Member, IEEE

Page 1233.

Abstract:

This paper presents performance measurements of fiber-optic flexural disk accelerometers. The flexural disk acts as a mass-spring element to which the fiber is bonded, such that an acceleration causes a strain to be imposed on the fiber which is measured interferometrically. Simple analytical models have been written to calculate the responsivity and resonant frequency of disks under various boundary conditions and the results of the models have been shown to be in good agreement with the measured responsivity for the case of moderately thick disks. Six optical fiber accelerometers based on flexural disks of different thickness and supports have been demonstrated to exhibit a responsivity in the range from 28 to 39 dB re 1 rad/g with a resonant frequency between 2.4 kHz to greater than 5 kHz, respectively. Of the designs considered, the centrally supported disk is shown to give the highest combination of responsivity and bandwidth. A centrally supported disk has been demonstrated to exhibit a flat response up to 2 kHz and a responsivity of 37 dB re 1 rad/g which when combined with an interferometric phase resolution of 6 µrad/, would give a minimum detectable acceleration of 84 ng/. We have attempted to cover all aspects of the sensor design including responsivity, bandwidth, cross-responsivity, phase response and size and find that a complicated compromise between all of these design parameters is required to achieve the optimum performance.

References

  1. R. J. Urick, Principles of Underwater Sound, 3rd ed.  : McGraw-Hill, 1983, ch. 3.
  2. P. J. Nash, "Review of interferometric optical fiber hydrophone technology", Inst. Elec. Eng. Proc.-Radar, Sonar Navig., vol. 143, no.  3, pp.  204-209, 1996.
  3. D. A. Brown, "Fiber optic accelerometers and seismometers", in Proc. Acoust. Particle Velocity Sensors: Design, Perform. Applications, AIP Conf. , vol. 368, Mystic, CT, 1996, pp.  260-273. 
  4. D. L. Gardner and S. L. Garrett, "Fiber optic seismic sensor", SPIE Fiber Optic and Laser Sensors V, vol. 838, pp.  271-278, 1987.
  5. R. D. Pechstedt and D. A. Jackson, "Performance analysis of a fiber optic accelerometer based on a compliant cylinder design", Rev. Sci. Instrum., vol. 66, no. 1, pp.  207-214, Jan.  1995.
  6. D. A. Brown and S. L. Garrett, "An interferometric fiber optic accelerometer", SPIE Fiber Optic and Laser Sensor VIII, vol. 1367, pp.  282-288,  1990.
  7. S. T. Vohra, B. Danver, A. Tveten and A. Dandridge, "Fiber optic interferometric accelerometers", in Proc. Acoust. Particle Velocity Sensors: Design, Perform. Applications, AIP Conf., vol. 368, Mystic, CT, 1996, pp.  285-293. 
  8. S. T. Vohra, B. Danver, A. B. Tveten and A. Dandridge, "High performance fiber optic accelerometers", in Proc. 11th Conf. Opt. Fiber Sensors, 1996, Paper Th5-5,. pp.  654-657. 
  9. Y. Shindo, N. Tsuchida, K. Dobashi and H. Kamata, "Fiber-optic accelerometer", in Proc. 12th Conf. Opt. Fiber Sensors, OSA Tech. Dig., vol. 16, Washington, DC, 1997, pp.  202-205. 
  10. D. A. Brown, T. Hofler and S. L. Garrett, "Fiber optic flexural disk microphone", SPIE Fiber Optic and Laser Sensors VI, vol. 985, pp.  172-182, 1988.
  11. D. A. Brown, T. Hofler and S. L. Garrett, "High-sensitivity, fiber-optic, flexural disk hydrophone with reduced acceleration response", Fiber and Integrated Optics, vol. 8, pp.  169-191, 1989.
  12. W. C. Young, Roark's Formulas for Stress and Strain, 6th ed.   New York: McGraw-Hill, 1989.
  13. Roark's Formulas for Stress and Strain, 6th ed.  : McGraw-Hill, 1989.
  14. C. D. Butter and G. B. Hocker, "Fiber optic strain gauge", Appl. Opt. , vol. 17, no. 18, pp.  2867-2869, Sept.  1978 .
  15. W. T. Thomson, Theory of Vibration with Applications, 4th ed.   Cambridge: U.K.: Chapman and Hall, 1993.
  16. Theory of Vibration with Applications, 4th ed.   Cambridge: U.K.: Chapman and Hall, 1993, pp.  66-67. 
  17. Theory of Vibration with Applications, 4th ed.   Cambridge: U.K.: Chapman and Hall, 1993, pp.  83-84. 
  18. A. Leissa, "NASA Tech. Doc. SP-160 N70-18461", 1969.
  19. S. W. Tsai and H. T. Hahm, Introduction to Composite Materials, New York: Technomatic , 1980, pp.  388-394 . 
  20. P. P. Benham and R. J. Crawford, Mechanics of Engineering Materials, New York: Longman Scientific and Technical, 1980, pp.  129-132. 
  21. A. Leissa, "NASA Tech. Doc. SP-160 N70-18461", 1969.
  22. E. Skudrzyk, Simple and Complex Vibratory Systems, University Park, PA: The Pennsylvania State University Press, 1968, ch. 8.
  23. W. C. Young, Roark's Formulas for Stress and Strain, 6th ed.   New York: McGraw-Hill, 1989.
  24. J. P. Dakin, C. A. Wade and M. Henning, "Novel optical fiber hydrophone array using a single laser source and detector", Electron. Lett., vol. 20, no.  1, pp.  53-54, 1984.
  25. M. Martinelli, "Time-reversal for the polarization state in optical fiber circuits", in Proc. 10th Conf. Opt. Fiber Sensors, 1994, pp.  312-318. 
  26. A. D. Kersey, K. J. Williams and A. Dandridge, "Characterization of a diode laser pumped Nd:YAG ring laser for fiber sensor applications", in Proc. 9th Conf. Opt. Fiber Sensors, Florence, Italy, 1993, pp.  255-258. 
  27. G. A. Cranch and P. J. Nash, "DERA Internal Report", June 1999 .
  28. M. L. Henning and C. Lamb, "At-sea deployment of a multiplexed fiber optic hydrophone array", Proc. Conf. Opt. Fiber Sensors, vol. 2, pp.  p. 1/84-1/91, 1988.
  29. G. A. Cranch, "DERA Intern. Memo.", Aug. 1999.
  30. J. Bush, A. cekorich and C. Kirkendall, "Multi-channel interferometric demodulator", in Proc. SPIE Third Pacific Northwest Fiber Optic Sensor Workshop, vol. 3180, May 6 1997, pp.  19-29.