2000 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

IEEE Transactions on Antennas and Propagation
Volume 48 Number 5, May 2000

Table of Contents for this issue

Complete paper in PDF format

Analysis and Design of Doubly Curved Piezoelectric Strip-Actuated Aperture Antennas

Hwan-Sik Yoon, Gregory Washington and Wilhelmus Hendrikus Theunissen

Page 755.

Abstract:

Recently, aperture antennas that have the ability to change their reflector shape through the use of piezoelectric actuators have been studied. The results show that those antennas can exhibit beam steering and beam shaping in the far field. However, many of the previous studies have been confined to cylindrical shape antennas. This study examines the use of"doubly curved"antenna structures to achieve better performance in controlling an antenna's coverage area. The spherical antenna is modeled as a shallow spherical shell with a small hole at the apex for mounting. Following Reissner's approach, a stress function is introduced and two governing equations are derived in terms of the stress function and the axial deflection. Next, the surface deflections are evaluated from the calculated stress function and the axial deflection. As actuators, four lead-zirconate-titanate (PZT) thunder actuators are attached along the meridians separated by 90°, respectively. The forces developed by the actuators are expanded in a Fourier series and fed into the governing equations as boundary conditions at the outer edge. Finally, the deflection versus applied voltage is calculated analytically and its effect on the far-field radiation is given.

References

  1. L. Silverberg and G. Washington, "Modal control of a corner reflector to maximize far-field power", Microwave Opt. Technol. Lett., vol. 8, no. 5, pp.  260-264, 1995.
  2. P. R. Lawson and Y. L. Yen, "A piecewise deformable subreflector for compensation of cassegrain main reflector errors", IEEE Trans. Antennas Propagat., vol. 36, pp.  1342-1350, Oct.  1988.
  3. P. J. B. Clarricoats, A. D. Monk and H. Zhou, "Array-fed reconfigurable reflector for spacecraft systems", Electron. Lett., vol. 30, no. 8, pp.  613-614, 1994.
  4. W. L. Stutzman and G. A. Thiele, Antenna Theory and Design, New York: Wiley, 1981.
  5. P. W. Howells, et al. "Special issue on adaptive antennas", IEEE Trans. Antennas Propagat., vol. AP-24, pp.  575-764, Sept.  1976.
  6. B. M. Howard and N. E. Tornberg, "Thermoadaptive and electroadaptive antennas for smart skin applications", in Panel 3 Phys. Electron. Workshop Smart Electromagn. Antenna Structures, Nov. 1996.
  7. T. M. Au and K. M. Luk, "Effect of parasitic element on the characteristics of microstrip antennas", IEEE Trans. Antennas Propagat., vol. 39, pp.  1244-1251,  Aug.  1991.
  8. G. Washington, "Smart aperture antennas", Smart Mater. Structure, vol. 5, pp.  801-805, 1996.
  9. H.-S. Yoon and G. Washington, "Piezoceramic actuated antennas", Proc. SPIE Conf. Smart Structures Intell. Syst., vol. 3328, pp.  156-163,  1998.
  10. H. S. Tzou, Piezoelectric Shells: Distributed Sensing and Control of Continua, Boston, MA: Kluwer, 1992 .
  11. P. H. Larson, "The use of piezoelectric materials in creating adaptive shell structures", Ph.D. dissertation, Univ. Delaware, Newark, DE, 1994.
  12. E. Reissner, "On the determination of stresses and displacements for unsymmetrical deformation of shallow spherical shells", J. Math. Phys., vol. 38, pp.  16-35, 1959.
  13. H. Kraus, Thin Elastic Shells, New York: Wiley, 1967.
  14. Y. Rahmat-Samii and V. Galindo-Israel, "Shaped reflector analysis using the Jacobi-Bessel series", IEEE Trans. Antennas Propagat., vol. AP-28, pp.  425-435, July  1980.