1999 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

IEEE Microwave and Guided Wave Letters
Volume 9 Number 11, November 1999

Analysis of Three-Dimensional Embedded Transmission Lines (ETL's)

Page 447.

Abstract:

Three-dimensional (3-D) circuits promise a significant reduction in circuit size and cost. In 3-D circuits, a few transmission line configurations are encountered including the offset stripline and the embedded transmission line (ETL), a stripline-like topology with two dielectrics. The ETL may have either two ground planes (similar to an offset stripline) or one ground plane (similar to an inverted microstrip). There is a need for an accurate solution to predict the effective dielectric constant and characteristic impedance of these transmission line structures. This paper provides an accurate (1% maximum error) closed-form empirical formula for the effective dielectric constant and compares it with full-wave simulations. In addition, this letter provides an empirical formula for the characteristic impedance and compares it with full-wave simulations of the structure. Close agreement between the two approaches is observed over a wide range of parameters.

References

1. A. Fathy et al., "Design of embedded passive components in low-temperature cofired ceramic on metal (LTCC-M) technology," in IEEE MTT-S Dig., vol. TH1E-1, 1998, pp. 1281-1284.
2. K. Nishikawa et al., "A compact V-band 3DMMIC single-chip down-converter using photosensitive BCB dielectric film," in IEEE MTT-S Dig., vol. MO2C-4, 1999, pp. 131-134.
3. --, "Millimeter-wave three-dimensional masterslice MMICS," in IEEE MTT-S Dig., vol. TU4B-5, 1998, pp. 313-316.
4. I. Toyoda et al., "Highly Integrated three-dimensional MMIC single-chip receiver and transmitter," IEEE Trans. Microwave Theory Tech., vol. MTT-44, pp. 2340-2346, Dec, 1996.
5. A. M. Darwish, A. Ezzeddine, H. C. Huang, and M. Mah, "Properties of the embedded transmission line (ETL)--An offset stripline with two dielectrics," IEEE Microwave Guided Wave Lett., vol. 9, pp. 224-226, 1999.
6. H. Tserng, P. Saunier, A. Ketterson, L. Witkowski, and T. Jones, "K/Ka-band low-noise embedded transmission line (ETL) MMIC amplifiers," in IEEE Radio Frequency Integrated Circuits Symp., vol. IX-2, 1998, pp. 183-186.
7. --, "Embedded transmission line (ETL) MMIC for low-cost, high-density wireless communications applications," in IEEE Radio Frequency Integrated Circuits Symp., vol. III-4, 1997, pp. 41-44.
8. H. Wheeler, "Transmission-line properties of parallel wide strips by conformal-mapping approximation," IEEE Trans. Microwave Theory Tech., vol. MTT-12, pp. 280-289, Dec. 1964.
9. S. B. Cohn, "Characteristic Impedance of the shielded strip transmission line," IRE Trans. Microwave Theory Tech., vol. MTT-2, pp. 52-57, 1954.
10. E. Yamashita and R. Mittra, "Variational method for the analysis of microstrip lines," IEEE Trans. Microwave Theory Tech., vol. MTT-16, no. 4, pp. 251-256, 1968;
11. R. Collin, Field Theory of Guided Waves, 2nd ed.New York: IEEE Press, p. 273.
12. E. Yamashita, "Variational method for the analysis of microstrip-like transmission lines," IEEE Trans. Microwave Theory Tech., vol. MTT-31, p. 1051, 1983.
13. Sonnet Software Inc., Liverpool, NY.
14. S. B. Cohn, "Problems in strip transmission line," IRE Trans. Microwave Theory Tech., vol. MTT-3, pp. 119-126, 1955.
15. M. R. Gunston, Microwave Transmission-Line Impedance Data.London, U.K.: Van Nostrand, 1972, pp. 38-39.
16. I. J. Bahl and R. Garg, "A Designer's guide to stripline circuits," Microwaves, p. 90, 1978.
17. B. Bhat and S. K. Koul, Stripline-Like Transmission Lines For Microwave Integrated Circuits.New Delhi, India: Wiley Eastern Ltd., 1989.