2000 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

IEEE Transactions on Microwave Theory and Techniques
Volume 48 Number 6, June 2000

Table of Contents for this issue

Complete paper in PDF format

Watt-Level Ka-and Q-Band MMIC Power Amplifiers Operating at Low Voltages

Youngwoo Kwon, Member, IEEE Kyungjin Kim, Emilio A. Sovero, Member, IEEE and Don S. Deakin

Page 891.

Abstract:

Ka-and Q -band watt-level monolithic power amplifiers (PA's) operating at a low drain bias of 3.6 V are presented in this paper. Design considerations for low-voltage operation have been carefully studied, with an emphasis on the effect of device models. The deficiency of conventional table-based models for low-voltage operation is identified. A new nonlinear device model, which combines the advantages of conventional analytical models and table-based models, has been developed to circumvent the numerical problems and, thus,to predict optimum load impedance accurately. The model was verified with the load-pull measurements at 39 GHz. To implement a low-voltage 1-W monolithic-microwave integrated-circuit amplifier, careful circuit design has been performed using this model. A Q-band two-stage amplifier showed 1-W output power with a high power gain of 15 dB at 3.6-V drain bias. The peak power-added efficiency (PAE) was 28.5% and 1-dB compression power (P1 dB) was 29.7 dBm. A Ka-band two-stage amplifier showed a P1 dB of 30 dBm with 24.5-dB associated gain and 32.5% PAE. Under very low dc power conditions (Pdc < 2 W, Vds =3.4 V), the amplifiers showed 29-dBm output power and PAE close to 36%, demonstrating ultimate low-power operation capability. To the best of our knowledge, this is the first demonstration of watt-level PA's under 3.6-V operation at 26 and 40 GHz. Compared with the published data, this work also represents state-of-the-art performance in terms of power gain, efficiency, and chip size.

References

  1. J. J. Komiak, W. Kong, P. C. Chao and K. Nichols, "Fully monolithic 4 W high efficiency Ka -band power amplifier", in IEEE MTT-S Int. Microwave Symp. Dig., June 1999, pp.  947-950. 
  2. M. K. Siddiqui, A. K. Sharma, L. G. Callejo and R. Lai, "A high power and high efficiency monolithic power amplifier for LMDS applications", IEEE Trans. Microwave Theory Tech., vol. 46, pp.  2226-2232, Dec.  1998.
  3. Y. Hwang, P. D. Chow, J. Lester, J. Chi, D. Garske, M. Biedenbender and R. Lai, "Fully-matched, high-efficiency Q -band 1 W MMIC solid state power amplifier", in IEEE Monolithic Microwave Millimeter-wave Circuits Symp. Tech. Dig., June 1996, pp.  167-170. 
  4. S. J. Nash, A. Platzker, R. Wohlert and C. Liss, "A 1.4-W Q -band GaAs pHEMT MMIC", in IEEE GaAs IC Symp. Tech. Dig., Oct. 1997, pp.  283-286. 
  5. S. C. Cripps, RF Power Amplifiers for Wireless Communications, Reading, MA: Artech House, 1999.
  6. W. Curtice and M. Ettenberg, "A nonlinear GaAs FET model for use in the design of output circuit for power amplifier", IEEE Trans. Microwave Theory Tech., vol. MTT-33, p.  1383,  Dec.  1985.
  7. D. Root, "Technology independent large signal non quasistatic FET model by direct construction from automatically characterized device data", in Proc. 21st European Microwave Conf., Sept. 1991, p.  927. 
  8. D. E. Root and S. Fan, "Experimental evaluation of large-signal modeling assumptions based on vector analysis of bias-dependent S -parameter data from MESFET's and HEMT's", in 1992 IEEE MTT-S Int. Microwave Symp. Dig., June 1992, pp.  255- 258. 
  9. Y. C. Chen, D. L. Ingram, H. C. Yen, R. Lai and D. C. Streit, "A new empirical I--V model for HEMT devices", IEEE Microwave Guided Wave Lett., vol. 8, pp.  342-344, Oct.  1998.
  10. D. M. Pozar, Microwave Engineering, Reading, MA: Addison-Wesley, 1990.
  11. Y. Kwon, E. A. Sovero, D. S. Deakin and J. A. Higgins, "A 44-GHz monolithic waveguide plane-wave amplifier with improved unit cell design", IEEE Trans. Microwave Theory Tech., vol. 46, pp.  1237-1241, Sept.  1998.
  12. Y. Kwon, D. S. Deakin, E. A. Sovero and J. A. Higgins, "High-performance Ka -band monolithic low-noise amplifiers using 0.2-µ m dry-recessed GaAs pHEMT's", IEEE Microwave Guided Wave Lett., vol. 6, pp.  253-255, July  1996.
  13. W. Boulais, R. S. Donahue, A. Platzker, J. Huang, L. Aucoin, S. Shanfield and M. Vafiades, "A high power Q -band GaAs pseudomorphic HEMT monolithic amplifier", in IEEE MTT-S Int. Microwave Symp. Dig., June 1994, pp.  649-652. 
  14. T. H. Chen, P. D. Chow, K. L. Tan, J. A. Lester, G. Zeil and M. Huang, "1 W Q -band class A pseudomorphic HEMT MMIC amplifier", in IEEE MTT-S Int. Microwave Symp. Dig. , June 1994, pp.  805-808. 
  15. J. C. L. Chi, J. A. Lester, Y. Hwang, P. D. Chow and M. Y. Huang, "A 1-W high-efficiency Q-band MMIC power amplifier", IEEE Microwave Guided Wave Lett., vol.  5, pp.  21-23, Jan.  1995.