2000 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

IEEE Transactions on Microwave Theory and Techniques
Volume 48 Number 7, July 2000

Generic-Device Frequency-Multiplier Analysis-A Unified Approach

Page 1134.

Abstract:

In this paper, a unified generic FET frequency multiplier theory is developed. The predictions of this approach are consistent with previously published results, but this theory is valid for an extended set of bias/drive regimes of operation. The model can be applied in the cases of both single-and double-sided current clipping. The model predictions are presented as contour plots. These provide a general summary of the harmonic generation characteristics of a generic device, and the optimum bias and drive conditions. For a frequency doubler, 15% more second harmonic power than that indicated by a conventional analysis is predicted for the optimum configuration. For a frequency tripler, an alternative biasing condition is proposed, which yields interesting advantages over previously published approaches. The predictions of the unified generic approach are shown to be consistent with the corresponding contour plots for a specific device, as determined from a numerical Fourier analysis of its current waveform as given by a nonlinear device model. The trend in measured conversion efficiency versus input power for a fabricated GaAs monolithic-microwave integrated-circuit C frequency tripler, with an output at 56 GHz, is compared with the predictions of the generic and device-specific models, with acceptable agreement being achieved.

References

1. A. Gopinath and J. B. Rankin, "Single-gate MESFET frequency doublers", IEEE Trans. Microwave Theory Tech., vol. MTT-30, pp.  869-875, June  1982.
2. S. A. Maas, Nonlinear Microwave Circuits, Norwood, MA: Artech House, 1988.
3. H. Zirath, I. Angelov, N. Rorsman, C. Karlsson and E. Kollberg, "A balanced W -band HFET doubler", in Proc. European Microwave Conf., 1993, pp.  837-839. 
4. J. S. Augusto, M. J. Rosario, J. C. Vaz and J. C. Freire, "Optimal design of MESFET frequency multipliers", in Proc. European Microwave Conf., 1993, pp.  402-404. 
5. R. Gilmore, "Octave-bandwidth microwave FET doubler", Electron. Lett., vol. 21, no. 12, pp.  532-533, June  1985.
6. T. Hirota and H. Ogawa, "Uniplanar monolithic frequency doublers", IEEE Trans. Microwave Theory Tech., vol. 37, pp.  1249 -1254, Aug.  1989.
7. H. Fudem and E. C. Niehenke, "Novel millimeter wave active MMIC triplers", in IEEE MTT-S Int. Microwave Symp. Dig.,, pp.  387-390. 
8. I. Angelov, H. Zirath and N. Rorsman, "A new empirical nonlinear model for HEMT and MESFET devices", IEEE Trans. Microwave Theory Tech., vol. 40, pp.  2258-2266, Dec.  1992.
9. K. Yhland, "FET mixers and nonlinear FET models for intermodulation analysis", Chalmers Univ. Technol., Go¨teborg, Sweden, Tech. Rep. 287L, 1998.
10. I. Angelov, "Chalmers nonlinear HEMT and MESFET model-Extraction procedure part A: Extraction of the current part of the model", Chalmers Univ. Technol., Go¨teborg, Sweden, Tech. Rep. 25, July 1996.
11. B. N. Lyons, E. O'Ciardha, P. Duffy, M. Fehilly and S. Cremin, "Design and evaluation of a 60 GHz MMIC", presented at the 1999 IEE Millimeter-Wave Circuits Technol. Commercial Applicat. Colloq...